NetScaler (ADC) - Pablo Legorreta

Redirect HTTP to HTTPS without DOWN server

By Pablo Legorreta NetScaler (ADC)2 Comments

Redirects on NetScaler permanently mark the service as down (read: RED status) which inevitably always leads to questions as to why it was configured with something marked down. There is a better way to perform HTTP to HTTPS redirects on NetScaler.

Enabling NetScaler SNMP

By Pablo Legorreta NetScaler (ADC)

In my recent journey to automate alerting and monitoring, one of the most useful tools for gathering information is SNMP. Setting this functionality up on a NetScaler is simple and can be done through the GUI and CLI. The data for SNMP needs to go to an SNMP collector such as Solarwinds, LogicMonitor, etc.

Configuring IPv6 VIP on NetScaler

By Pablo Legorreta NetScaler (ADC)

How to load balance and leverage a mix of IPv4 and IPv6 addresses on NetScaler. Process depicts how to load balance and IPv4 back-end server with an IPv6 front-end address.

NetScaler Gateway SmartAccess PoSh

By Pablo Legorreta Citrix, NetScaler (ADC), Virtual Apps & Desktops (CVAD)2 Comments

NetScaler Gateway SmartAccess depends on XML requests which need to be enabled. In the past, there was a policy to Trust Requests Sent to the XML Service Port, however, this policy has been removed from the Studio Policies